Nope I did not. I supported the boat, took it off the trailer with the intention off deforming some rivets back to a sealing state. During...
26inch setback My bracket with 26 inch set back and 60 inch platform almost complete with the design so I can make some component prints. 3D...
Based on that data I need 25 inches of setback to "overtilt" the yamaha 150.
Awesome! thanks for the data.
tilt clearence diagrams If anyone knows where to find tilt clearance diagrams for Honda, Yamaha, and Merc. in the 115 to 150 HP I would really...
I agree that plasma cuts both, and will work. My preference would be to remove some contaminants from plasma edges before welding.
I am only assessing based on what I have read on forums, and threads like this one. I will look for those diagrams you speak of. I have not run...
Bracket construction So based on what I have read 25 inches is the minimum shaft length that should be used on a high horse power outboard...
21' 73 holiday I am thinking i am going to do the same with my 73 starcraft holiday. What shaft length OB will you go with? I have read some...
Hi, I recently read some threads on some other boat forums that strongly recommend to only use 25 inches shaft outboards mounted to a transom...
I found some replacement aluminum fasteners from Fastenal that are 2024-T4. This alloy can have slightly under 5 percent copper as an...
reply Yes appeared to be 6 veneers per 3/4 inch ply... The screws went through the aluminum angle that is riveted to the hull also, that's...
The old core Finally got the round to-it I needed to pull the old core... I was surprised it held together when I pulled it out... especially...
Thanks PAR. I appreciate the post on my thread PAR. I had hoped you would drop in and lend your knowledge, and experience. I really appreciate...
Epoxy thickening I have read on here to use products like West 404, and west 406. for thickening epoxy. Also Bateau.com recommends use of wood...
paint after I do all the epoxy work?
Transom & Deck So, would the deck have been the BC exterior as well? I believe what I pulled up off the deck was 3/4". Any thoughts as to...
73 21' Starcraft holiday IO - New transom & deck Hello all, I have finally gotten around to getting the outdrive, and engine out of my boat....
Sure. Good advice, I was thinking I would introduce myself here. Some forums encourage an introduction. Didn’t see that here but thought it...
If aluminum oxides and cut kirf contaminants are not removed from the weld joint prior to welding, you will most certainly have discontinuities if...
