I have a set of 22 ft. Center console molds for sale. Hull, one piece deck, center console, and hatch cover molds. No stringer mold. Located in...
mold help I think that you should contact a product supplyer in your area that could lead you in a good starting direction. There are guys on...
tja Hello, Go with MVP. I have a Magnum mini pro gelcoater I bought new. Works very well. I also have a older Magnum chopper gun with a 20ft...
Tja Go to www.chemtrend.com and click on locations. Call the number listed and they will be able to give you the dealer closest to your...
Tja Hello, If you can use a ball point pen on the gelcoat it's ready for layup.
Tja Hello, I went into Greenwood's web site and they have changed it some what. It isn't clear if they cover labor any more. Last time I was at...
Tja Hello, XL panels made by Greenwood products are used both in aluminum and fiberglass boats. It is guarenteed for life including labor last...
Tja I was wrong about J being the month of September. J is for October. You start with A for January and progress from there. Usually the month...
Tja Hello, The serial number will not end with a letter. The letter indicates the month it was built. I believe the j would indicate the month of...
Tja Hello, I haven't looked at any resently but if you do a google search for marine surface drives you will find a lot of manufacturers. If i...
Tja That is a lot of dead rise for a jet drive. I would think that a surface drive would work much better with that kind of horse power....
Tja Find and use Chem Trend PMR as per directions. This is a semi permanate mold release that works very well. If the mold is new use sealer15...
Tja Sand the bottom with 80 grit. Areas that need to be filled, use epoxy thinkened with micro baloons. Sand repaired areas to finish. Coat...
Tja The cultured marble industry use both modeling clay and also wax filets to creat radiuses. If you have two pieces that bolt together I don't...
Tja I forgot to mention use the gray 2000/ 2001 The white doesn't roll on as nice as the gray. I also use one inch x six inch sponge rollers from...
Tja I didn't think that you were going to leave the boat in the water. Most epoxies don't work well as a top coat as they are suseptable to uv...
Tja Use mat between the two sheets of plywood in the transom. Not woven roving. The mat will bond the wood together much better. Do the baulk...
Tja If you read the labels you will find that awgrip and most other paints are not designed to be applyed below the water line. I'm assuming that...
Tja Are you sure that the gelcoat is too thin. Tooling is tranparent and may look thin when it may be ok. Regelcoating would be my last resort as...
Tja Hello, When you prepare a plug you want to wet sand to as fine of grit as posible say 1000 grit. Then use an electric buffer and compound to...