thanks folks, it's not very wide, so I am going to lay down some csm then go over with the milled fiber putty, this should give me a strong and...
It's on the deck of a boat, 1/2" plywood core. The deck is just gel coat over CSM. It's a TwinVee, finish is similar to a carolina Skiff. [IMG]
I had to cut out some delaminated CSM with gel coat on top. I was just going to put CSM back in the repair, but I started to think. What if I...
I know that I could use coosa blue water 26 for my deck to replace the 1/2" plywood core that was in there prior. But, if there another core that...
Thank you very much for the help!
PAR, if My last layer of glass for a deck is 1708 with the biax side up, what should I put over that last layer before pulling fairing compound?...
I was talking about cutting the whole area out and then laying down 6 inch x 6 inch squares of kiln dried marine treated plywood. I do like the...
So the deck of my sea cat is getting spongy in some spots. I plan to just cut the top laminate off the sole, then remove the bad wood core....
gonzo?
Where would I find a poly adhensive? I was planning on using the poly I had to glass the 1708 over the coosa. you think one layer of 3/4 mat...
My hatch has succumbed to the elements. I plan on using a sheet of coosa for the repair the same thickness as the old ply. I plan on removing...
Thanks again!
Thanks, you're correct, nothing should be touching the underside except where it touches the stringers and I'll put some type of bonding putty there.
I meant the the underside of the plywood that i would use as a core for the deck which sits on top the stringers to seal out moisture and stop the...
that makes a lot of sense. Thanks. As for the bottom of the ply facing the bilge, a layer of 1708 would be fine or probably overkill?
Thanks, so I imagine if I laid down one layer of 1708 and then a layer of 1.5oz csm on top that would be plenty enough if I am painting on top and...
you are correct, but I don't have to worry about the bottom and I would just lay down some mat before I put down the non skid coating. So I...
What would you reccomend? On the top before I put down non skid and on the bottom to seal it up? I'm at the point where I am seriosly...
Probably vinyl ester
I would like to know what you guys normally use as the last layer of glass before pulling fairing compound and blocking it out. It seems like I...