The transom is separate from the splashwell and derives none of it's strength from the splashwell per the designer. The engine is a 40hp Yamaha...
I am restoring a 20' Tolman skiff and will be adding a sealed self bailing deck to the boat. The splashwell bottom was rotted out so I have cut it...
Thanks. I am going to make them the original length per the original plans, 10 feet from the bow. The plans call for screwing them to the...
Thanks! This boat has spray rails that extend 10' back from the bow. Some guys run them all the way to the transom to give the boat a reverse...
Bottom is glassed. [IMG] [IMG]
[IMG] Letting it set this way for a couple days prior to trimming to fit. Thanks rwatson for the link and everyone else for their advice. I'll...
Like this? [IMG] Around 45-50 pounds needed to get it flush. Think the epoxied scarf joint will hold?
Possibly and have not ruled that out. I am hoping to not use up a ton of expensive hard to get epoxy joining two 1/4" ply pieces if I don't have...
The Tolman is built with stitch and glue construction. I can bend the ply without hearing any cracking but in doing so I had to apply a fair...
Thank you Wayne. The keelson is made by forming a fillet of thickened epoxy 3" wide and narrows as the deadrise increases. The fillet is then...
Couple more pics to show the entire project. [IMG] [IMG] I am ready to buy the rest of the wood so any more input would be greatly...
Thank you Wayne. Are you referring to Dr. Joseph Daisy? And regarding plywood, I am afraid the best grade of plywood available here is exterior...
Who is Joe??? Looked at table 1.2. Searched "minimum bend radius" as I have never heard that term until now. Math was never and will never be...
I am in the process of replacing most of the bottom of a 20' Tolman skiff. I will be using ACX covered with glass and epoxy. The plans for this...