Good suggestion It sounds very good idea. In Dallas area there are many used boat at low price. I think I will start looking for a good target....
Thanks about the information It seems I will need to look other way to finance my dream, if the dream still may fly. I am not sure any more....
Boat market It seems boat is not a high demand merchandise. I was intended to build small boats to support my project to build a large 28 ft...
Market demand What is the best sale in the boat market? It seems boat is not hot item by itself. I have no experience in market place.
Thickness of transom Thank you. To know that 1" is over kill do give me a peace of heart. I am thinking about my next boat. This first boat...
transom installation According to the boat design, the transom is backed up by the rear seat, transfer the pushing from the motor to the rear...
About the tilt position The owner's manual suggest to trailer the motor tilt because the propeller is about 1' 2" below the bottom. Propeller...
Lock on transom a risk to break the transom? I also read from other forum members about the transom thickness. I decide to install 1" transom....
Thank you. You are always provide prompt answer. Thank you very much. I will do take the motor and put it in trunk.
I finished my boat building of a 14 ft flat bottom skiff. I installed extra thick 1" transom to support an outboard motor. I purchased Susuki...
I did coat the plywood with epoxy resin. I did as you said. The plywood was coated with epoxy resin before fiberglass. But I think because I am...
Thank you I never thought of the city waste collection center as a resource of paint. Certainly will go to see what I can get.
Thank you both for the patience and information. I think I got the idea. My boat is a small 14 ft skiff. I will use it once or twice a week...
I am a first time boat builder. I purchased a 14' skiff marine plywood kits, fiberglass tape, fiberglass cloth, epoxy resin to build the skiff....
Thank you I thought about the same solution last night. But since many of the vacuums are on the edge, between the bottom of the hull and side....
This is my first boat built from kits. Everything seems smooth until I put fiberglass on plywood hull. The instruction of kits does not include...
I am brand new in boat building. Just purchased a wood with glass/ epoxy kits. My intention is using this kits to build a 14' skiff to test and...
Found Glen-L boat site with reference of plywood dealer in DFW I found that Glen-L.com has a list of comprehensive plywood dealers. I did not...
Marine plywood for fiberglass coating? May be someone able to give me some advise on the following ideas: I am thinking about using one-off...
Thank you! I am waiting for my boat plan arrive. When I got my boat plan, I should know better about the thick and quantity of plywood I need.