I really haven't looked into this much. Part of my diligence will start with a design capable of packing a 200HP.
Thanks Gonzo as mentioned I'm at the exploratory stage. I have a long ways to go before the welding begins. I have a nice 22' Slickcraft with a...
I am no where near a sketch but thinking something simple like this.
Any idea the thickness the plate should be?
Thanks Squidly hadn't thought of getting someone to glue it together. Was thinking bolts. Will have to scout out a welder if I proceed.
Aluminum angle iron and plate.
""Brand new lengths of 6061 aluminum angle. The 1.5” is 3/16” thick and 24’ long. The 1” is 1/8” thick and we have it in 20’ and 14’ lengths""...
Anyone seen or know about plans on building one. I have some plate and access to some 3/16th” thick 1.5” aluminum angle iron. Wondering if it’s...
Chris I stopped the Reno when I was going to have to replace the wood on the top of all the stringers. Sides of stringers were fibreglass but top...
I haven't measured the transom but probably close to the same height as the one on the Sangstercraft that I switched from I/O to Outboard, and...
I have the pod but when I get into it after the engine drive removal I will decide on the pod or cutting out a hole to mount the outboard on the...
I’d have a kicker its a 9.9 Yamaha 4 stroke for the trolling pod has a mount for it to.
I have an outboard engine pod. And a 125hp mercury outboard probably a little small for this Slickcraft boat considering it’s pushing around this...
When I have to make the inevitable repairs, I’d rather be looking for Mercruiser or Volvo parts. And the right donor boat it would be financially...
I have a 75 Slickcraft 22' I inherited. Beautiful hull. Has a complete 225 OMC setup in it, only 597 hours on engine runs great. I'd like to...
I've rebuilt transoms before using polyester resin and mat and never had a problem. And will have at least two knee braces between the two outside...
Was thinking glue to prefab it but I could do the same thing with my polyester resin and cloth .
Pretty much made up my mind to use 3/4” 1/2” 3/4” glued with titebond111 glue .
Rebuilding the floor and transom on this bellboy. Ready to install transom but wondering if the previous 1.5” thick transom and two sheets of mat...
Everything is glassed. And I have done the pvc pipe thing through the stringers before, looks like I will be again.
