The following technical documentation specifies minimum bend radius for various thichknesses of ply wood panels:...
Here is a minor challenge for you designers out there which would yield useful information: Off-setting a transom mounted, tiller controlled,...
I stumbled upon this video in YouTube. You hull designers may find it interesting. Here is a boat designed to make as big a wake as possible while...
What are the pros and cons of an outboard powered displacement speed catamaran for Florida ICW cruising? There is lots of info on a sailing cat vs...
For a 24 foot, flat bottom, 7 foot beam, flat-iron displacement skiff, used for general recreational cruising (not a work boat) what is an...
I am less than 2 months from my move to Jacksonville, FL and a house which is 7 minutes from the ICW on Beach Blvd. I have a good fishing skiff (I...
Would the subject boat make a good displacement cruiser with a low power outboard? No centerboard, but perhaps ballast in the bilge.
I am just completeing a wooden 14 foot flat iron skiff. Max bottom width is 50" fiberglass over 1/2" plywood with rocker forward and almost flat...