I am still progressing on thew amphibious vehicle. have started to add fuel tanks onto transom exterior two tanks alongside jet drive. ducting air...
Here is my dilemma i am building an amphibious vehicle, and want to know if wheel well areas( only open at bottom, like an inverted cup) will...
Hello: I am trying to design air supply to radiation my Amphibious Vehicle project. have some design details . since the engine and radiator...
want to know if there is a generic local paint supplier for priming coat on underwater aluminium boat hull. GP 48 general paint /OR? not sure off...
I have a 12 degree transom plate for an American turbine jet drive, and need see if all cable /shift/steer cables openings can be sealed ,because...
I have a boat project my own hull design and need to know maximum draft at rest for the american jet drive that is powered by 350 chev i heard...
update on the amphibian. have to add air ducts to engine compartment make access doors/top exhaust is FW cooled . mufflers are in a seabed ,...
what do you use for catholic protection (anodes) for small aluminium hulls in salt water? I think hull and components have to be grounded to...
latest photos of my project.I may have to add trim tab/tanks at transom to get stern draft down and compensate for mid engine weight
I hope to get info on self righting design principles. on a hull that is based on older SEA SKIFF style hull> Thanks Rick
i tried to hijack an existing site, but here is my keel cooler design ideas, with hope of suggestions. on my amphibious vehicle project I intend...
I have posted in the past year, and thought i would get latest photos out on my progress on an amphibious vehicle. powered by 350 chev, with a...
i have an American turbine jet drive and need to kjknow how o ring seal fits on jet drive barrel? there does not seem to be a groove to accept o...
Hello: I am a new member and hope to chat and exchange ideas for my project. i have started to fabricate an aluminium sea sled hull of 20ft. x...
