Thank you very much for your comment and advise. Helped to sort out a lot.
Hi I was wondering about your thoughts or opinions of fuel fuel consumption for the below designs. LOA: 56ft/ B 25ft/ D 2.5ft Dsplcmnt:...
Thank you Eric.
Eric, Once again, thank you very much for your thoughts and advise.
Eric, very appreciated for your comment. If you please give me one more advise, what is your opinion of building m/h or building times for...
Thank you Adler, but where can I get this software? Can you advise?
Hi everyone, I was just wondering if someone advise us for the following queries. To build a 55ft steel trawler that is for commercial...
Hi everyone, Just have a quick question and hope to get your advise. For the net weight of 20tons steel material (before cutting and...
Hi, I was wondering if you have boat building M/H in your thoughts through your building or design experiences. I am after 18meter x 3meter...
Carteret - Thanks for your comment.
Gonzo- the web site has very good stuff i've been looking for. Thanks alot for your help.
tunnels, I understand what you are meaning. In other case, I have 7 spray guns paid dollors and am still using them for 7years now. Some are new...
i was thinking of peninsular brand cause that might be cheaper...
I am looking for the engine and stern drive combinations. engine H/P 260~300 ranges with bravos either alpha. any comments?
Thank you all. thanks for the helps.
Hello Tunnels, thanks for the comments. I also had a work shop at Hwasung of which now closed. I am moving down to the South bound for bigger...
Hello Tunnels, I have recently develpoed an automated epoxy compound despenser and I am using this device for fairing and composite mold building...
thank you ondarvr, I will check their web site.
Thank you Michael, Hyundai SEASALL brands were launched a few years ago yet not many builders in here are using them as they are not cost...