Don't forget there once was a great boat building ind. there You guys eaver hear of the Cubavich? I had a chance to talk with Mike Rybovich. He...
Thanks Par Not sailing yet, but very close. I learned a lot on the first boat, and I am really proud of the finish I got on this one. I even...
I have a 45' mast that was broken. I realize that it is passable to sleeve it, but can it be done without loosing +/- 4 ft. and would the cost of...
Paint Questions---I have Awl Griped 3 boats and I'm still asking Awl Grip tech support questions. You can mix primer and paint Mfg's., but it's...
I'm ahead of you. I have been pulling out the wires, checking them and then re-pulling to new GFI's and new outlets. So far it has been ok, and I...
Thanks, That is the information I needed.
No green Thanks, But the AC is wired with Brown, Black, And Blue, No green. Actually, I can use the wires anyway I want, because I am rewiring...
One other quickee I'm dealing with French wiring. Am I correct --Black is positive, Brown is netural, and blue is ground. ?
Thank you Ike, I guess the answer is I did it O.K., but if I want to spend money I can make it better. That will be after the sails are up....
Nor did I. I described the way the batteries were wired in the initial question and also the way the Charger was wired. (4 pos. studs, one ground...
Sorry guys, but, No one has answered my question yet. Except to correct my 9th grade physics mistake of calling a series, parallel. So I'm to...
I am rebuilding a "hurricane boat". I was able to Flush and put new acid in the 4 batteries. I obtained an older model 60 amp 4 bank battery...
Only mix a small quantity at a time and apply when wet. Do not try to fill a deep area all at one time and when the filler starts to set do not...
Great link, --Lots of good information on this site, thanks. Good for price comparison too.
Thanks Sam, I wasn't sure if regular Contact adhesive would work. I have worked a lot with it doing mica work. I was planning to varnish the...
I don't think that will work Epoxy is great for areas that can be clamped evenly while setting, but a large flat surface like a bulk head needs a...
The wood bulk heads in my sailboat are trashed beyond the normal sanding & varnish restore. I have access to good paper backed teak veneer, but I...
Hy Par welcome back from "retirement" missed your wise words. Just to add a wrinkle to this thread. Even though I'm a teak man. I have been...
Thanks for the "heads-up". Since you are a dealer maybe you can answer my questions. I did recive the brochure and sample pac, but no prices or...
Thanks Buckle I just recived about 50 sample molds from Gibco. It looks as if one might be a match. I'll know Saturday. They didn't supply a...