I don't know, looks like they just filled the gouge with resin then laid some cloth over it and added gelcoat. There are a couple of 'bits' where...
Yes, I understand the methods and thankyou. So, to summarise, a repair from the outside is OK, use some 450csm on a 12:1 taper, then fair and add...
Hi Guys, I have a small 4m Avon Searider rib with a flooding hull. It is not cored, just fibreglass and gelcoat. It has some trailer bracket...
Csm What weight of CSM would you recommend e.g., 450g?
What do you think chaps? Perhaps if I had sanded around the corner instead of into it at an angle it would have lessened the severity of the...
Bathtubs don't have hatches :p. I have Signal White, Pure White, Traffic White and a Plastic Padding gelcoat repair kit in stock. Of the three...
. This sanding is fine and is not taking too much off the laminates, but the gelcoat was thick, so maybe only one or two levels - we'll see....
Sadly, have run out of time today. The final picture is after a levelling pass with a DA :) Whaddaya think Tunnels -grind the white bits out...
[/U][/I][/B] :confused: Sorry, was refering to types of mat, West System or other etc. Keep up!
Thankyou Tunnels. Sledge hammer to crack a Walnut? Inside the transom shows good. Shall, with a very fine bit, grind the cracks and inspect...
Paint all over Thankyou Par for the reply. First underlined quote: what is the material that might be required ? Second underlined:...
Thankyou Par. Should the crazing/cracks be taken down to the laminate (holes drilled either end) then filled with Gelcoat?
Removed old gelcoat Thankyou all for your help. All non original gelcoat has been removed, no damage to the laminates could be found should a...
Morning All, Following the recent purchase of this craft, would it be possible for someone to advise on the preferred method of repair for...