That just might work! Thanks And or this one too: http://www.woodenboatstore.com/prodinfo.asp?number=400-071
Yes and I also thought so, and I think for the most part you are right. Such as those mahogany covered barrel backs and such! But it seems some...
Yes I agree, and the builders did a nice job building it! I am finding out they call this type of boat a Runabout....
I can see the boat on the cover is really close design wise; If you can dig that info up I would appreciate that. Thank You
Anyone recognize this boat design? I am interested in Finding the plans for it. Thanks.
Yeah, I am doing my model as if I were to build it. I saw this tug actually being built, its 150' x 46' x 27' I wish I would have took some...
This was done in a program that reads the lofting data automatically, so what ever is there in the offset charts you get in 3D. The frames are...
Well here is what the first 34 frames look like.....
since 1000mm = 1M then two of those values that you posted above may have needed to be converted from Meter to Millimeter in order to add them....
Sounds reasonable to me, thanks for your help. My co-worker and I are writing a program that automatically reads in a lofting chart and plots all...
PAR, its marked baseline and I see no + or - signs in the lofting tables. Based on this picture would you say all my lofting lines will be from...
:eek: LOL, I am going to convert it to all feet inches and decimal form. I grew up on the imperial units of measure so for me and my area and...
Not sure if I understand the "scaled" idea, I was thinking as you said that just offsetting the plate thickness would work no?; but then again I...
I am glad you noticed that because I am not really sure what "plane" I should be using to offset my height from when developing my sections,...
Hi guys, am I on the right track here? I drew this at frame 20 based on my table of frames and offset chart. If so I will continue as I am doing...
Ok one last question if you don't mind; the above figures just for my own clarification are for the main structural fabrication and welding. So...
Yes good idea welding some of the frames and stiffeners to hull sections flat then put them in place and hope that they don't distort to much from...
Thanks for that information! I guess I could do a percentage cost comparison on the $750 Metric Ton to try and come up with a figure for...
Hi- I was wondering if anyone would have any idea what the cost per ton is when estimating the cost on say a large tug boat? Any tips in this...
I'm new to the boat building DIY world and before I buy plans/patters for my first build I thought I would get some advice first such as the...