problem solved. thanks
Looking for reliable glass/layup shop in Wisconsin/MN/Michigan/IL? guys, there are a lot of different folks on here from a lot of different parts...
Sorry I have been a a way for a while and for some reason my auto notification for post updates has not been sending to my email. Anyhow...thanks...
point taken. Believe me..we will do as little as possible to make it work :)
all good stuff guys. Thanks for the inputs. I am thinking we might grind a bit of the hook out of the hull as well as some of the strakes aft of...
a couple of photos of the profile along with how its riding underway in the water.
also here are a few links to some video we shot just playing around. This is smooth even throttle to pop up on plane. Lightly loaded it starts bow...
To answer your questions. The boat runs very flat and true. I would not describe it as bow up. In fact when we built the plugs for the boat we...
Do you have any suggestions for adding lateral plane to the hull a bit forward of the pump? Or any ideas in theory?
do you guys think adding a small rudder to the bottom of the venturi would solve anything or will it only make it harder to break free of that...
Thanks Barry, we are going to put it back in the water today. The linkage is actually very tight with almost no slop in along the way. I used the...
Thanks for the input. The complaint isnt so much that it centers itself..thats great..its that its hard to break from the center as speed pics up....
Sea Trial Ok guys so we finally got the boat in the water today down in Florida. Couple of updates and am hoping for some input. Looking for...
I think we are going to CNC a front and back plate out or starboard perhaps and then put in a control arm that works at a 4 to 1 ratio in a...
Unfortunately this control box only has 1 so I have to try and accommodate it the best I can. We thought about drilling our own hole farther up...
Ok guys I am looking for other ideas or perhaps suggestions here. I need to convert the stock throttle actuator on a project to a more basic...
For our sake I hope we did not improve it too much!
cmckesson, thanks for the input. If I am reading your post correctly you are thinking that the jet thrust will be limited in being able to turn...
thanks barry. re jet vanes this package is actually designed to work together. The intake size and pump/impeller etc are all from same...
Barry, Thanks for the input. She will be powered with 70hp and 90hp power plants depending on our fuel mapping when we are done. Certification as...
