I have searched but not found one.
My VHF antenna coax came pre-made and has a regular PL-259 connector on the Antenna end and a FME connector at the radio end. An FME to PL-259...
I have a older fiberglass cruiser with a solid fiberglass hull. There is a settee on either side in the main salon and just above the settee is a...
I have a 26' Allweather. If you are not familiar with this boat it is a round hulled displacement power boat. ALLWEATHERBOATS.COM...
I have a 26' trawler with an inboard three cylinder Yanmar diesel. This boat is unusual in that it has keel cooling and dry exhaust. The boat is...
Chuck, Do you have an electric priming pump in the system? Or do you rely on the mechanical pump primer?
I am going to install a Racor 500 series filter on a 30 hp diesel engine. Is there a limit to the cumulative distance tank -filter-engine? I...
I have done a lot of plywood/epoxy/fiberglass boat building so I understand filling the weave and this is something I have considered. By "filler"...
I just bought a 1980 Allweather built in 1980. This is a small (26') trawler type boat. The Allweathers were utiltarian boats and this one is an...
I have used 3m VHB tape to attach acrylic windows to a boat with very good results. I have a new, old boat with two windshields. They are standard...
The Yamaha T25 has a 2.42:1 gear case versus the Suzuki 2.09:1 case. The Yamaha will also accept props to 12.25" versus the Suzuki 11". I do like...
Thanks everyone. I was exploring possibilities and it doesn't look like the 40 ETEC is a good idea. I will probably go with a Yamaha High Thrust 25.
The online spec sheet for the 40 lists gear ratio as 2.90:1. Gonzo do you think what I propose is grossly overpowering?
I am building a displacement boat with outboard power. Hull speed formulas/ hp required say 10 hp for 6 knot hull speed for a straight shaft...
I have a small boat with an outboard and rotary cable steering. It is a power boat with the steering console on the bulkhead separating the...
Kevin, Would you be interested in building this for us? http://www.kastenmarine.com/pram.htm We would want the 12' model.
Thanks everyone for the very informative replies. it looks like it is possible if the builder has the required skill level. I have imagined a...
I am researching designs for a 10-12 foot row boat. The boat will be used as a courtesy dinghy for anyone to use to row out/back to their anchored...
The engine is a 2003 model and in the owners manual and the service manual the rpm range is given as 4000-5000.
The boat is a semi displacement design so is not meant to be very fast. It is an adapted, by the designer, sail boat hull. About 900 pounds or...