I am surfacing a plug and I have a lot of duratec sanding primer left. I wonder If I can use this with the high gloss additive for the finish...
Planning on wet storing aluminum hull in Florida.( High speed Cat) that is frequently trailered.Hull (including wet surfaces are awlgripped)...
I'm trying to troubleshoot an electrical problem - aluminum hull, twin honda outboards, two batteries.Boat is out of water on trailer. Port...
Have an electrical leak(DC 12 v.) in an aluminum hulled boat. I am trying to troubleshoot. Should there be any continuity between the negative...
anybody know the whereabouts of cal connell WPB, Fl. of rybo runner fame? passed away?Wonderful visionary man.
Anyone have a rough idea how speed would vary simply by altering boat weight? Assuming same hull shape,wetted surface,power etc.I know this is not...
I am looking into building a male plug by attaching large flat panels to a wooden framework of transverse bulkheads( supported longitudinally as...
have considered airex tried and true as hull coring but I am intrigued by nidacore.Only seen jefferson marlago with nida cored hull-any other...
Looking to do large flat table glass panels for plug building. Naive question perhaps, if I use mica or melamine,\to surface the table.how should...
I was thinking about making a plug by covering plywood bulkhead/rib framing with thin plywood but the filling/fairing issue will be overwhelming....