photos and price. goodfolksfinancial@gmail.com
Please send pix of boat and molds. goodfolksfinancial@gmail.com
I am surfacing a plug and I have a lot of duratec sanding primer left. I wonder If I can use this with the high gloss additive for the finish...
Planning on wet storing aluminum hull in Florida.( High speed Cat) that is frequently trailered.Hull (including wet surfaces are awlgripped)...
Im not sure what you are trying to accomplish.Does the original set up have an outboard well inside of a cut down transom?I.e. typical old style...
I'm trying to troubleshoot an electrical problem - aluminum hull, twin honda outboards, two batteries.Boat is out of water on trailer. Port...
Have isolated problem to the honda outboards.The negative ground to the engines completes the circuit thru the hull,any thoughts?There may be a...
Have an electrical leak(DC 12 v.) in an aluminum hulled boat. I am trying to troubleshoot. Should there be any continuity between the negative...
An epoxy barrier coat such as interprotect by interlux followed with bottom paint is the usual way to go. Why bother with gelcoat?
Make sure the existing glass is cleaned of contaminants,then key it with 80 grit or coarser. Epoxy will stick to existing polyester very well.New...
Thanks,Eric.This seems consistent with my prototype's performance.
simpler.Cal Connell of rybo runner fame had a set up with twin engines and twin shafts where you could run both shafts off one or two engines....
Actually, they are pizza ovens. Delicious thin high gluten crust,NY style, grande cheese and fresh pack tomato sauce from stanislaus in...
What is the purpose of the 18 footer? The hysucat foil is an adaptation that allows for much greater speed and fuel economy on a cat designed for...
ccosa Ive only fooled around with this product a little- made a transom tansducer mount for an aluminum hull about 6 mos ago-still seems in good...
anybody know the whereabouts of cal connell WPB, Fl. of rybo runner fame? passed away?Wonderful visionary man.
Any thoughts along these lines?- 2 planing hulls same shape,size etc. Hull one Hits 30 kts with 200 HP. Hull 2 weighs half as much. Estimated HP...
Anyone have a rough idea how speed would vary simply by altering boat weight? Assuming same hull shape,wetted surface,power etc.I know this is not...
I have been researching this issue and , if you are not making compound curves, a flat panel lay up is the way to go. Lay up flat panels on a flat...
JEM-EMAIL ME gasdok007@earthlink.net re what type of services you provide.