thank you TANSL.i will consider those machinery. rxcomposite-actually my question is about engine air intake only.maybe after this i need to...
how about the pressure?
Hi, now i'm designing engine room ventilation (air inlet) for a boat with 30 knots speed.the air is from outside.i want to know is the any...
yes, it's aluminium..
yes, the situation is the ramp is resting on the ground.i understand your explanation about the load distribution, but how about the inclination...
thank you mr.tansl :)
Hi everyone, How can i know the maximum load of the ramp hinge can withstand?or how i can determine the size of the hinge for certain loads? for...
thank you for the explanation. now i understand it.. :)
is it?before this i compared with the curve of planning (fast patrol boat), its curve was smooth increased.
Hi, I have run a resistance analysis for a utility boat, and the curve shown was like in the picture below. is it normal if the result like...
i got that idea..thanks to all..:)
actually, i just need to show that the design is not safe.the problem is i didn't know whether i need to set the main deck as compartment or not.
based on the GA, it's a hinged joint,penetrate to the main deck.is the joint give any difference to the result?so, i should set it as compartment...
the ramp is not watertight joint. main deck is at the same level with the ramp. main deck is watertight.
Here I attach the pictures of 3D and damaged compartment that i set.by looking to the picture, i saw that the water level is already exceed the...
I have problem in running the analysis of damage case. if the boat has ramp at the fwd part and i want to show the flooding condition at main...
Hi, i'm a new user of hydromax.i got a problem analyzing a model of patrol vessel using severe wind and rolling analysis (IMO criteria-intact...
Hi, i need help regarding on the shell expansion using maxsurf structure advance.i follow all the step from the manual pdf and run the...
I'm facing another problem right now..if some control points already compacted..is there any way that i can separate them back?
ok..tq..now, i found the way.. :)