Hi Folks - My current floating docks, built mainly from rough sawn 2"x8" hemlock boards for framing, with large welded metals corners, axles and...
Hi Folks, Many of you have helped me when i first built my aluminum 25" Glen-L design Double Eagle powerboat a few years ago. I have used the...
Hi PAR and others- I saw a post where you mentioned having a source for a 27hp Kubota based engine. Do they have anything in the 15- 20 hp range,...
Hi folks, I know that I am somewhat overpropped now, after adding cupping and a couple of inches of pitch - 2 years ago, I could hit 3300rpms...
Hi Folks, I have had my home-built boat in the water for 3 summers of limited use/ testing, but due to other priorities, never bothered to see...
Hi Folks, I had a failure of the oil cooler for my Velvet drive 71C 1:1 gearbox, attached to a Cummins 4BT. I have a spare oil cooler which is a...
Hi Folks, I have had my (home made) 25 ft aluminum power boat on the water for the 2nd summer, with a temporary center console and no windshield/...
hi folks, unfortunately, noticed steam in the exhaust and low coolant (coolant reservoir seemed full enough before first run of season, but...
Finished installing new Moeller 27 gallon tank and connecting lines as well as new Baldwin fuel water separator housing and filter (picked up at...
Hi Folks, Hoping to get some advice in deciding to place the more permanent 9.9hp Mercury 4 stroke (on used heavy duty Garelick Hydra assist...
Hi folks, As most of you know I have sea trialed my new (home built) aluminum 25ft double eagle power boat a bunch of times now and am generally...
Hi Folks, Our 25ft aluminum Double Eagle is inboard/ shaft drive, powered by a 150 hp Cummins 4bt. Boat is still not finished but we used last...
Hi Folks, First, I want to thank all members here who have helped me get to this point. I have had my home-built 25 ft aluminum powerboat in...
Hi folks. Sorry to be longwinded....This used engine was keelcooled with dry stack. I added a heat exchanger off of V8 chev I believe. I likely...
Hi Folks, I am sure it worked a couple of years ago when engine ran for testing - but when I now turn key the oil gauge immediately "pins out"...
Hi folks- finally installed my new-to-me used capilano 1250 helm and 150 or 175 series ram - think 175 but will have to measure as no label on...
Hi folks, I am putting a used Capilano 1250 helm and 175 series ram in the 25' power boat currently being built. manuals (and Tony's tips from...
Hi Folks, Looking for some input, especially from those with inboard engine and inboards systems installation... I confess - never did buy the...
(i.e. between prop and lower skeg / rudder support bar) I made a mistake in building my lower rudder support (placing it above the lower skeg...
Hi Folks, Building a 25' power boat and will be doing final engine/gear install soon, and am on a budget. It will have a used Cummins 4BT...