tunnels- The motors actual dimensions are 9.25" diameter, the motor housing is 15.92" with an overall length (including both end shafts) of...
mr hot rod- Thanks for the info. I'll definitely be getting that book! I will be drilling the shaft hole at some point in the near future, and...
CDK- I wasn't sure what was out there in the marine world as far an overdrive type transmission. Since the DC motors have such high torque at...
Ok Stumble, sorry for the 'personal attack'. I am my ideas though... But I will say that was your most constructive post yet. J/K. Maybe if you...
Hmm, where to start. Funny how a question about the angle of a strut gets turned into a hater party. Leave it to an attorney :P Well, as far as...
One other thing Eric, if I run a cavitaion plate off the transom it could make up some of that distance right?
That's a huge help Eric, thanks again! CDK- Those numbers on the graph are baseline numbers using a 350amp controller. I'll be using Netgain's...
Thanks tunnels, I'll check it out. I dont want to reinvent the boat part, thats why I'm here.
Well Stumble, you raise some good points, but a few things I'll have to disagree with. Much like the car I drive, It may have a peak power output...
Thanks for the info about how far the prop needs to be away from the hull. That was one other thing I was curious about, so that took the guess...
Logically thats what I was thinking, but I'm by no means an expert when it comes to boats. I wasn't sure if there was some other reason for...
I'm pretty new to boat building and boats in general for that matter. I was wondering if someone could explain the advantages/disadvantages of...
