Hi all, I have a new issue with optimax 150. Was working quite well then it immediately stopped idling. The air and fuel injectors seem to be...
Hi all, just a quick question for optimax enthusiasts. What should I check on a 2006 mercury optimax 150 if there's no spark from any of the...
Hi all, has anyone ever connected dual steering rams to two outboards, if so will u please guide me through via a diagram or tutorial. Thanks kindly
Hello folks, I just developed a difficulty on an optimax 225. I'm getting a 'sensor fault ' on the smartcraft tachometer, how do I diagnose which...
Hi all, has anyone ever replaced the diaphragm in an air pressure regulator on the optimax? I'm trying to replace a ruptured one but there's a...
Hi all, I need some help with getting a johnson 115 v4 to run on all cylinders. The starboard cylinders have good spark and compression, new...
Hello all, just a quick question; are the optimax 150 and 225 air and fuel injectors the same, can they be interchanged? Thanks.
Hello Folks, I just launched the boat two days ago after a two week break and when I tried to fire up the motor it refused to start, I did the...
Hello everybody, what could be causing the fuse on a 2 cycle 115 johnson to be blown? I narrowed the fault to the store wire (black with white...
Hi all, I have just replaced a bad choke system on a 2003 115 johnson two stroke but got lost at reinstalling the vacuum hoses and would really,...
Hi all, is anyone able to assist me in sourcing the original battery compartment locks for a 1985 25' mako? I've been searching for months...
Hello all, i'm doing some repairs on a 1978 robalo 190 center console and want the console to look original , but i'm unable to because i only...
Hi all, what could cause the smart craft tachometer gauges to suddenly stop working? Each is connected to an optimax 225 gen2 and was operating...
Does anyone, by any chance, have a diagnostic tool or software for the 2003 and later optimax 225 for sale?Please let me know. Thanks
Hi all,i've just repaired the floor on my 21foot wellcraft but I don't know how to get the diamond design finish;does anyone know how to achieve...
Is anyone able to help ,please. I still need to know how to connect a few tank to the smartcraft wiring of an optimax 225.Thanks
Hi everybody,does anyone know where to get a wiring diagram for 2003 optimax or how to locate the cinnection for the fuel tank? Thanks
Hi all,i've recently bought two 225 optimax with the smart craft electronics and i installed them according to the documentation but the display...
Hi all, i have just bought a pair of optimax 225's with the smartcraft system .I installed the motors and made all the connections through the...
Hi all,i'm repairing the transom of a 21ft.wellcraft but there is a slight curve that has me puzzled.After removing the laminates i realize how...