thanks for all the help got it narrowed down to dirty carbs going to clean them tommorrow
I have a 1997 50 hp johnson outboard went to run it for first time today cranking over good but not firing boat ran great when i pulled it last...
is there anything i need to be careful of taking the water out
Thanks for everybodys help so far still trying to figure things out getting almost to the point of taking it to someone but im an hvac mechanic...
ok so they will be at the end of the pontoons at the backon the bottom
do not believe there are any plugs on the bottom of the toons but there are 3 plugs along the top of each pontoon is this where in need to add air...
24ft god frey aqua patio
where is the best place to drill the hole and are the pontoons sectioned off on the inside this is my first pontoon boat dont know much about them
thanks for most of your responses a guess i should have been more specific obviously I looked for the obvious damage where it could be leaking I...
Just pulled my 24 ft pontoon out today for the end of season I found out that I have water in my pontoons anyone have any ideas on on how to get...
Thanks for the advice I had to leave before he finished the starter job so im not sure if the pulleys were spinning our not.But now I have...
I have been helping my brotherinlaw work on his 3.0 merc cruiser the problem we are having is when we try too start the boat it is making a really...
Thanks for all the help this was a good lesson not to do it again what a pain in the but i can see why marine mechanics make good money
thank you for your reply tank is not removeable i believe i got all the gas out of the tank today is there anything i should add to the tank...
went to use my boat today and to my own stupidity after mixing the oil in i forgot to put the gas cap back on when i backed the boat in i got...