Hi, I find this interesting post about my problem http://www.metalboatbuilding.org/phpBB3/viewtopic.php?f=64&t=250&start=10
I already grind and fill the air bobbles (they occur only on the pin wood, like rails on the bottom and bumpers on the sides, not on the plywood,...
Let say, if i make bottom grill with dimension 1'x1' and expend those ends which are perpendicular to central line of the boat to make them ribs....
Take a look on this post, what do you think about this approach...
I was thinking to use the basic plan and to modify it according to some general rule (rule of thumb). For example, there is need for more battens...
Thank you for reply, Ok, I understand the problem, can you help me how to make the changes in the plan, or give me some reference from where I can...
All I'm afraid is rotting and splinting of plywood. Wood work is relay good. So now I'm trying to seal pores in fiberglass and not to spend so...
Hi, I'm planing to make this boat from aluminum. http://svensons.com/boat/?p=MechanixIllustrated/BudgetHouseBoat All ideas and suggestion are...
Thank you for this advise I'll do that, and you are right I have air trap in between fiberglass layers, not blisters like you explain, I'll grind...
ok, I'll do blisters (I'm still in phase of building it) but how to sill pores in polyester sheeting to stop osmosis
What kind of primer do I need (pls specify the type not the brand) ?
Most of the blisters are between coats of fiberglass (I put two layers) and some are on pinewood (ribs, rails on bottom and bumpers on the bottom...
Hi, due to number of reasons I made 10 foot fishing boat from polyester and plywood with inside ribs made of pinewood. Since polyester is not...