Thanks alot it is a design exercise but i wanted to know how close can i go to the reality
Sorry, it is 26 meters and thanks for your answer
Dear all I am working on design of 26 aluminum catamaran, after using DNV rules, the shell plating thickness was 4 mm my question is how feasible...
Thanks alot for your answer, now it is clear for me
Thanks for your help what I mean with cross beam is that structure connecting the two demi hulls, sorry if I used wrong expression for that the...
Thanks for your answer, This catamaran is designed for inland water way region when the wave height is 0.75 meters and speed is 12 knots In BV...
I mean the difference between round bilge and hard chine (Deep V) hull shapes
Thanks for your reply, I am working on an educational project which will not be achieved in any boatyards, I was curious about what is the value...
Dear all I am working on a 30 m aluminum catamaran project and I did all necessary calculation for determining the scantling for the cross beam...
yes I mean that hull which has a discontinuity on its surface in the transverse direction
Hi all Sorry if my question seems to be a trivial one. what I know is chain hull shape (or knucke) is used for high-speed planning hulls and is...
ok i will check PNA, but is there are like direct instruction on how to do it, may be a flow chart or something like that ?
I think the propeller is with nozzle but I didn't choose the propeller size yet .... I'm asking to know where to start about propeller sizing...
Thanks for your help is there any kind of books or papers I can use as reference for these kind of calculations ?
Hello all Can you help me to calculate the required engine power for tug boat with 40 tons Bullard pull? the type of propeller will be ASD is...
Dear Sir Thanks for your time ….as you said file transfer may cause problems. I noted that there are too many points on each curve I'm new with...
Hi all I'm new with rhinocero software i had 3d lines drawn on AutoCAD and Iimported it into rhino as self training on creating surface it's a...
thanks for your answer Maxsurf templates are very limited In TRIBON M3 there was a module called "Form" it was a powerful tool to create lines...
Dear All Is there any software i can use to create new lines for a displacement ship I expect the input to be L, B, D, LCB, CP, CB, or CM, PMB...
Thanks alot @TANSL does the same thing go with web frames ?
