looks like an old munk i workd on lots them over the years
mold and plug building hello i have made lots of molds over the years and found that for making the plug we used epoxy for this as its a one...
hello all sorry for long to reply regarding welds as most of you no i beleve thear is lot to take in to acount for dealing with welds on both...
1974 to 1998 built prity much everything forum racing flat bottoms to full despoilment did few years in industrial tanks and stuff for...
this is a small problem i ran in to lots times over the years all the maker use diff things to make there nonskid with so i got in the habit of...
1 more note take a good look at the back shaft bearing if you have in the past hit things or the old shaft was Reilly bad it can and most...
you can get a center bearing and make a mount for it this will reduces Anny bends and make it run smoother at all times shafts are made of a...
there's some good after built paints made for this - one I know of is called steel cote its a self flowing paint so you don't need sand out all...
i believe the maker of them molds was in BC Canada i had worked for a shop had a bunch of them some years back they no longer make boats so i...
there is a bunch of shops in Richmond and north van you can try looking in to Elvis Marin in north Vancouver
life after boat building things get slow after doing same type work for 30 years 3 X no money left to travel but life is good still and i have...
remember to use water proof glues not water resistant uf 109 is a good marine glue i have used lots over the years this is a 2 part glue
mite have been a donzi boat
hi i have done this before and what i did was get my hands in some aluminum sheet and cut it to be about 4 inch tall facing off the side of the...
re strip planks laying planks works a lot better if you hot steam them then placing them you get better fit and you shooed make up some curved...
re holes in a swim step if shear is a spot on the step or a full step that's in good shape regarding the nonskid you can mask it off and apply...
in mold making is some things need no your plug in your case the part your using to make the mold frum you need to treat this like is going be...
re feeder you should give it little time to finish hardening 2 hours is plenty time for it
feeder when working with fiberglass resins is a few things is good to know about how things work like your gelcoting the mold then laying in the...
the name i believe your looking for is a river row boat this has the rowers seat facing the way the boat is traveling in so you see whats coming...
