PRM 80 Gearbox 2.04:1 ratio. This is a brand new item. Never installed/used. It is manufactured in England, has a cone clutch, forward, reverse,...
I considered the Hurth but found quite a few negative posts and wondered about their reliability. Further more they are 2 or 3x the price new of a...
Gonzo, I agree, 71C will suck up too much power. I see that can support up to 400 HP. Yes, I saw a few on ebay. The shipping cost is very high,...
Fred, I'm limited to the 10" by the hull design. The stern reaches out over the prop, and a rudder bracket runs underneath it. I'll be trailering...
I just don't understand why there aren't, or more likely, I can't find a small trany that would mate to a small sailboat engine. After all,...
The Borg Warner seemed like a good idea. The 71C series, 1017 model looked smaller than the others, but the BW site doesn't give clear specs. My...
Hi, I'm building a 19' motorsailer with an inboard engine. It is the Atkin design "Surprise"....
I am looking for a 10" dia., with a pitch of about 12. I can make adjustments to account for pitch variations, but want to keep pitch on the low side.
I am looking for a good, used inboard, three blade, RH 10" prop. Nothing useful has turned up on ebay or craigslist. Are there any good trading...
Hey, thanks for the reply. I guess I should have been more clear. I'm looking for info on electrical systems, not electric drives. As well as...
I'm building an Atkins design, "Surprise", a 19 foot motor-sailer with an inboard motor. The basic hull is done and turned right side up. I'm...
Thanks for the input Thanks for all your comments. Several points are well taken, and I plan to follow them. 1 - go with the planned design and...
I'm considering building a 20' power boat, something along the lines of an Atkins Rescue Minor or a Tolman skiff. Fuel economy is important to me...