You will shorten the life of many 12v led if the voltage goes higher, low voltage is better but the light will be dimmer. I would use the power...
Your flowcoat has paraffin wax in it. Paraffin can be found in most diesel fuel up to 20% of volume. So you do not need to worry.
leak is a reason for not to take the exhaust trough the transom under the water line like CDK said. But if you use fiberglass piping and laminate...
I´m looking for EVC-D or E installation manual in PDF format for downloading. I have done google search and have only found EVC-C on several...
I recently saw easy method to form clay for caulking molds. It was on concrete countertop website where they extruded the clay from caulking...
Overhead work can be made easy using the method DGreenwood describes. I do it a little different. I start by cutting the mat to exact size and...
If there are builders of boats, designers of boats and operators of boats reading this thread, why would they not answer the questions I asked in...
You are right, there is no need of dis-assembly. On that photo the convex and concave shape is bigger than I do it, but the purpose is to...
Some others seems to have ---non contributing ---syndrome :)
SamSam, I think you do not understand my description of how it is built. The half of the tunnel that is glassed with the hull is made on...
We are in the process of designing a new 10m commercial fishing boat, and are interested in using new way of fitting bow thruster to our boats....
I have posted this before here. Our tanks for diesel are made from vinylester inner layer and then gelcoated once and topcoated once. Baffels...
I use open circulation system, so it is geothermal water at 32°C/90°F during the coldest month of january at average of 0°C/32°F outside...
At what temperature are you are laminating? Minimum temperature to work with polyester resin according to many standards is 18°c/64°F . Tooling...
Note that 1ltr of resin is 1,1kg, so if you are going by weight at 1%, you would need 11ml of catalyst. Axel
If you are reading 16V from the dashboard meter, I would first check the voltage at the battery with good voltage meter. Voltage up to 14,7V is...
I would set up guide for the router on the outside of the hole and first cut the hole with straight router bit with the diameter of the bering on...
Salesman from Euroresins came by last week and I found the dispenser that I was looking for in his catalog.
Thanks for sharing. Could you share with us how you made yours, plug, layup, material? Axel
I am not familiar with the thickened epoxy method. The way I do it is when I use 12 mm bolt for the motor, I drill 16,5 mm hole and use 16 mm...