Asking copilot AI what is an excellent gasoline sealer for gaskets, etc Best choice: For gasoline-resistant gasket sealing, Permatex...
Also the tight area where the tank meets my framing does fit a 3" screw. But what I did was grind off 1/4" from the screw just in case. I did run...
another pic of the corner, got another epoxy coat. It is pretty decently smooth now. [ATTACH]
One can of Great Stuff foam did all this. I like it. It is easy to overspray, takes a light touch on trigger. And I am going to look for a longer...
Divers seeking lost shipwreck near Toronto find an even older mystery | CBC News
Amazon.com: 1/2" Female NPT in-Line Strainer with 60 mesh Stainless Steel Filter Screen (1/2“ 60 Mesh) : Industrial & Scientific [ATTACH]
Get rid of the sea organisms with a fine filter at the outlet of the thru hull. Had same problem on my boat with a 6 foot hose. Tiny seal life...
Couple pics of the bag. Cured in epoxy it sands down fully smooth [ATTACH] Open bag view, it is definitely green colored, homogenous, I have...
Couple more pics of the transom corner repair. I used milled fibers with epoxy, saturated cotton balls pushed into epoxy coated wood cavities....
Picture of cured epoxy from the mix container. Thin it bends without snapping, I bent up an edge no problem, can bend all the way over. Thickness...
What was failing for me, I was drilling half inch holes into white oak frames, then gluing in white oak plugs an inch long to hold new screws. As...
Interesting, This is not doing that. For example the dried material I remove from plastic mix containers remains flexible. I have not seen it get...
Omewoold Crystal Clear Epoxy Resin Kit, 1 Gallon, Durable, UV Protected, High Gloss Finish - Walmart.com I like the pumps. This is thin like oil....
Amazon.com: Milled Fiberglass 30-50 AC-C : Industrial & Scientific I have bought it 4 times, I think I have enough. It is clean, green, mixes...
[ATTACH]
So after filling, I place duct tape over it. And the screws, since these pieces are smallish, keep it lined up using tape. I pulled it off today,...
Other side one of the boards need some new wood grafted in on the corner. I carved some mahogany puzzle pieces to shape. These are now epoxied in...
This was another repair I had to make. OEM had a SS strip over the rear corner and the mahogany ends had rotted. I replaced the entire transom 20...
yes, I see the picture. You can try scraping the loose paint. Is that aluminum tape different from the thin shiny stuff used for duct work? And...
The paint can bubble without burning the wood, your hitting a paint surface with hot air, not the wood exactly. And you always have to sand...
