All the glass work is finally done I used all knytex biaxial glass. I just have to sand a do a final fill.
That Is Just The Styrofoam Back Support I did not start the layup yet. Hopefully this weekend. The guy at US composites told me to only do 3...
ok, here is a photo Progress is slow due to the winter. Last fall, I used a sawzall to remove all bad,delaminated fiberglass. Then I ground it...
thanks ...I am going to use epoxy resins and a strong knytexl cloth.....photos coming
Okay, how do I lay up the hull repair? It is finally getting warmer to start the repair. Quick question. I have the hole in the hull cut away,...
more progress I have to get my camera out tonite-usually it is not with me when I am working-too dusty. Anyway, I grinded the front bottom area...
I was going to originally use west system epoxy, but I changed my mind. I am using US Composites epoxy-they are out of florida. A lot cheaper, and...
I have to say, that all the dust really sucks. I had a tyvek suit on, gogles, and a dual cartridge p95 respirator with a fan blowing the dust away...
Well, I removed the engine, and degreased the engine compartment. I started to grind the inside area, and ground through all the delaminated...
Well I would not exactly say I am a newby. I did 2 transoms in the past, that turned out great. I am not a pro though and happily will take advice...
Thanks for all the information. This is a great forum. (Hey, no fighting you two..lol) Both have valid points. I have no access from the...
need a fiberglass expert ttttt
Hello, I just joined today, and need to repair my hull in 2 places on a 2000 maxum 2300 sr. I hit a very large rock doing 20 mph. Last check of...
