Here are some more PICs. These were taken right after it was painted, so they don't show the faded paint. I don't have the boat here at the...
I painted the boat last week. The hull from chime to rub rail were painted ICE BLUE and everything else was painted with Awlgrip Cloud white. The...
We bought two gallons of Epoxy primer and sealed the boat. It had a decent build, but much harder to block then 2K. After blocking the epoxy, I'd...
Suki, thank you for weighing in. I was hoping to get steered in one direction or the other, but like everything else there is more then one way to...
Can you PM me with a recommendation. PAR, what you are saying makes since, however it is difficult to find high build epoxy in the auto paint...
The boats pretty rough and needs a lot of blocking We have decided to go with an epoxy primer, then a fill primer (G2 polyester primer). The boat...
I like PPG also. What high build epoxy pri.er do you recomend? So what I think you are saying g is that I can use the K38 and then seAl it with...
I have been brought in to help my friend restore his Sea Craft. Most of the work has been done, some by me and some by another friend. The other...
Hi I am going to have a few questions comming up on my personal 18 foot ski boat. I have another post on here, but unfortunately I lost my...
I am back at it. Foam - I have placed the two part foam in most of the floor (back section left). The Transom - I used 3 layers of the...
Have you seen the flex mold by Glibco. MAS epoxies is the retailers who sells the product to the public. I think I am going to go this route...
non skid Yes, I am going with white, so that will probably be the one I use. Good to know that I can spray grip tex. I was wondering about how to...
I've talked with Cook Composite reps as well as Duratec reps. I think the Duratec is the best bet for getting a polyester or vinylester based...
OK....I will try the scotch brite.
The bite would be all the strands of the biax running in the same direction. Those are the high spots that got sanded with a sanding block. The...
Does the Duratec require that there be absolutely no shinny laminate? What about adding a layer of mat with epoxy resin onto the existing...
OK.....what about the sanding question? Is the light hand sanding I did good enough? I don't want to grind the fibers, I think you were the one...
which duratec product? OK....I could try that. I am also willing to spring for the Duratec. The only problem with abrating the surface is that I...
R U suggesting that Gelcoat might stick to the epoxy? I think I might be misunderstanding what you are saying. Do you mean do a soap and water...
Need Help! I am ready to glue in the floor. I have 4 sections that basically go from bulkhead to bulkhead. The tops of my bulkhead/stringers...