Does it make enough HP to haul all the wives at once?..... lol... sorry,, couldn't resist that one....... :p
At first glance it appears to have a ball socket like an Arneson... but it wouldn't work at all like that. The thing would just flop about at the...
I agree... it would be easier to find a used engine and outdrive combination. But he wanted to know if he could use an auto engine... I think...
I/O ( inboard/outboard)... is the same as a stern drive... A bravo outdrive is a fairly cheap outdrive that will take moderate power (about 350...
It's been done... I've seen GM powerglides used that way... sturdy trans.... two speeds... plus reverse...
In my searching for resins and prices... I have found that Epoxy is about five times the cost of Vinylester... and not much stronger.......
All this time I thought I had a problem with my eyes because I could see better in the periphery at night than straight ahead... thanks for the...
I'm not a boat builder... but I've seen pictures of it being done.... Usually there are stainless screws that go through the hull and have either...
Are you talking about fasteners for the mold?... Or are you talking about fasteners for the boat... If they are for the finished boat.. only...
I neglected to mention that how I was using the epoxy isn't something that West system epoxy was originally intended for. That was the reason for...
I replaced stringers and bulkheads in my fountain... I used epoxy and had great results with handling the epoxy and it's adhesion qualities... ....
Dang Woody.... sounds like the way to go.... until the hull burns to the water line because of a leaking fuel pump and a little spark from the...
How hard do you plan on running your boat? If it is a ski boat... probably not as hard as an offshore high speed boat. I'd suggest since the boat...
Wow!.. those are some neat ideas... thanks for the link.... :)
Well... you have only a few choices... you can go to a trans like a Borg Warner Velvet Touch... or spend the big bucks and go to a custom made...
What kind of outdrive? shaft? I/O...? How much money do you want to spend... and the reversing trans... just for backing up?
In one way... marine engines are remarkably like car engines.... they share lots of parts... If you were to check a lot of "high performance"...
If you have rot issues, then address them properly. There is no magic goo in a can that will turn dead wood into less dead wood, regardless of...
So... are you saying that for "one ofs" ,that the laminations can be layed over a plug....with smooth mat on top, and then gelcoated over the...
I saw on the tube the other day how they made kayaks out of plastic... they had a big rotary mold made entirely out of metal that was filled with...