I have a 30hp diesel engine that makes a lot of noise at air intake. The intake is round at 1.5" (38mm), my plan is to connect a 2.0" (ID) rigid...
Curious to know if you guys think these would work well. They are basically laminated ply just like plywood, have seen them used in construction...
Was ready to order zincs with intention to put a shaft collar (donut) zinc around shaft however, with props being cpp, they move aft and fully...
Are there any examples of this idea for a mototsailor? Actually 3 sails; one mast on each side with big square sail in the middle and triangular...
Pic of bottom keel with 4" × 21" × 1" thick ground plate (ground ribs in to get more surface area) with a 3/4" × 8" silicon bronze bolt. Epoxied...
Greetings, Does anyone here know how long galvanized bolts can hold up underwater? Bolts are 1/2" to be used to attach rudder. Have heard...
Greetings, Been using BC plywood and like the cheerful, happy look of the grain and its light color so would like to use inside at hull sides...
Still some time before it is needed but would like to know where to buy 100% latex rubber pads of 3" and 5". There are many who sell...
Greetings, Been trying to find threads on this and the info is scant. Do remember Tad insist that they be scarfed. Other than possibly being...
Plan to install 20' of 3/4" K type copper pipe to keel at port side. Its been awhile since i bought it but believe K type is the thickest of the...
Anybody know type of boat this is. He uses it for a video game supposed be "authentic"
Greetings, On the blog "The Sailing House Barge Autarkia" http://junkrighouseboat.blogspot.com/2017/04/working-on-12-volt-system.html on the...
Greetings, Found an older uniflite with a 6v71 which is new to me (thought they were all inlines). So far am considering using good parts for...
Greetings, Going over news today and found a fascinating article at www.lewrockwell.com by Gary North titled "Bad News for Somali Kidnappers:...
Having a problem understanding this type of construction and very little info available. Can someone describe or point where its being used or...
Have an 85' SD300 (turbo charged) and bent front of frame so it might not be worth repairing. The engine is in excellent condition and just broke...
Put this down on paper a few months ago after thinking about a boat that would present an actual full vee to the water (at rest). Have the old...
Greetings, This is a project that will need to wait re: T-27 but, what are some techniques that have been used to put wood paneling/strips to the...
Under 14' & 10HP requires no licensce/registration/titling in Ohio. Cutwater keel & polytarp rig. Daggerboard switches sides according to tack....
Greetings, There's an article at SpiegelOnline titled "A Legendary Ship's Final Hours Battling Sandy", still need to read entirely but, it...