on a catamaran with 75hp yanmar engines, 1100 hours each, they run ok until 2400 rpm, at 2600 and more one starts overheating. Already checked...
I have a diaphgram bilge pump, it is 12V and it is protected by a 10A fuse on the panel. Because of some rust on the body of the electric motor,...
I recently became captain of an european boat that comes with all his electrical system 220V 50hz … now as the boat is currently in mexico it...
a few months ago i bought 10 sheets of 1/2" okume plywood for an interior cabinet making project. I stacked them on top of another sheet of 3/4"...
Taking off the mast of an old boat this is what we found, a lot of corrosion at the partners and at the step. The step doesn't look so bad, but...
Hi, I'm rebuilding a fiberglass boat, and now i'm starting the interior furniture..... so what is the best wood glue for that?
I've been told that wiping down an old fiberglass surface with styrene (after cleaning and sanding) , re-activates the resin and improves the...
Hi guys .. my sailboat (1979) comes with a traditional stuffing box with the box itself screwed on the shaft log and bolted to the hull . I see...
I everybody lately i got puzzled by two yanmar manual on the same motor ... one says to change transmission oil every 250 hours ... the other...
what is the best idle rpm for a yanmar 100hp
Hi, I'm new using double bias (DBM 1708) so as I use to do with mat and roving, I measure my patches ,dry fit them, and carefully roll them...
how long should be waited before applying epoxi over a new polyester lamination?
after laminating PE how long should you wait to apply epoxi?
hey guys .. here in Costa Rica they don't sell acetone anymore, as it's a product used to process drug now by law it's not available anymore.......
Hi, the whole core of the deck of the sailboat i'm rebuilding is rotten. I'm going to replace it all with balsa and at the beginning I was...
Hi, rebuilding a fiberglass boat with an internal keel of concrete glassed over.. I have to replace part of the glass over the concrete, but...
Hi, I'm rebuilding a '79 42 feet ketch from the hull.. I'm planning on taping the bulkheads (3/4 marine plywood) to the hull with epoxy and...