So this is my next little project :) a Richardson Roving Gem and I need to adapt her to take wheelchairs to get the family out on the water....
So my boat sank back in May and it's been a bit of a job trying to find her the full details of what happened and the search so far can be seen...
I guy's I hope this is the right place for this, I'm just about finished my Glen-L crackerbox and as it was porpoising a bit on the first test run...
Back again for more help :D this is my 5lt mercruiser it's a new long block and I'm swapping over a few parts from a donor engine. [IMG] The...
Hi guys, I'm not happy with the finish on my build as some of the weave is showing through where the damp has got at it so I want to remove it...
Hi guys, on my build when the boat level the 2bbl mercarb is at 12 degrees and I sure it will increase when the boat is in the water,should I...
Here is a little slide show http://s753.photobucket.com/albums/xx179/fergalbutler/EVINRUDE%2018%20hp%20fastwin/?albumview=slideshow on how I got...
Hi guys anyone have any ideas on what to do, it looks like the weave was not wet out enough or some moisture got in.If I sand down to the weave is...
Hi guy's this is the crackerbox I am building and I would like to get some advice on the rudder, it has a plate on it to stop air been sucked in...
Hi guys I am building a crackerbox as you can see below one of the problems I have is the strut I got with the donor boat is a bit short and if I...
Hi guys I am building a crackerbox http://s753.photobucket.com/albums/xx179/fergalbutler/crackerbox/?albumview=slideshow and am thinking of going...
Hi guys, is there a rule of thumb on how far the prop can be from the rudder or the transom. I am building a crackerbox race boat but just for fun...
Hi, guys I am rebuilding a v8 for my crackerbox build and have bought a lot of chrome parts one of witch is a crossover pipe at the top of the...
Qd6vkPjEy4U&feature
You may have this already, if not it's a good read when things are slow....
Saw these on ebay and would like to get my hands on some but he is a bit over the top on shipping. Do any of you remember these, are they dimes,...
Hi all first post here and I am sure you guys will be able to help me along my way,I have just started on my second build its a 1954 crackerbox...