We are about to infuse a cap in a new mold for a 20ft skiff. The cap is completely flat except for the hatches, which have recessed gutters. The...
We've got three layers of 1.5 oz CSM on a 20ft mold we're making using a isopthalic tooling resin. We're going to do 12 layers total and...
I'm working on a 20'x 8' running plug. The plug surface still has a bit of "waviness" to it, particularly where the topsides meet the spray...
I ran a test infusion panel last night. The infusion stack was: 45/45 12 oz biax 0/90 12 oz biax h80 1/2" divinycell (perforated) 0/90 12 oz...
I've been wet bagging all of my parts to date but I'm about to make an order of infusion materials so I can make the switch. I'm infusing a...
I'm building an 18ft cored skiff in a mold. I've tapered my 1/2" divinycell core so that the laminate transitions to solid laminate at the...
Per my other post about IMC’s, I’m about to start an 18ft skiff built from a mold of my design utilizing cored laminate and epoxy resin. The last...
I'm in the process of finishing up a mold for an 18ft skiff of my own design. I'm adding plywood stiffeners to the mold and about to de-mold from...
Anyone here rolled and tipped polylon HP? I just purchased two gallons to do a skiff. The sales rep. at Sherwin didn't order the reducer but he...
I have a question about planing hulls with tunnels and aeration. As aeration enters the tunnel of a planing hull, How does it act as it passes...
I'm building a 17-ft boat out of divinycell/biaxial glass/epoxy. The hull is close to finished and was built off a wooden jib. For construction...
I'm planning on using a Dahlar release film and Econoply peel ply from airtech to vacuum bag some epoxy laminates. Do I have to use both these...
I vacuum bagged two bulkhead panels last night using a robinair 6 CFM pump. About an hour after turning the pump on, it overheated and shut off....
I have a design that I've put together using Delftship. I'd like to export my plate developments into a dxf file but I can't do this using the...