G'Day Again Friends I just happened to come across a new push pull gun at the right price and want to use that instead of the old spool gun. The...
Colleagues I have being rebuilding a certain hull for quite a while now, not to get too much into that, but a brief description a 20' planing...
Colleagues Still rebuilding this boat of mine but edging closer day by day, I have being searching for tilt cylinder rebuild kits and have found...
Colleagues I am coming nearly to the end of quite a lot of hull repairs I have done on a aluminium hull rebuild. They were originally corrosion...
Good evening All A very quick question, I have a run of approx 5.5m from battery's to Motor. Motor is a Volvo Penta AD31B and I have a twin...
Colleagues On my journey of rebuilding my tub, I have decided to total strip the bottom plates back to raw Aluminium and then ultra sound them to...
Colleges while in the middle of hull repair I thought about all the places the I may have missed finding corrosion holes in the aluminium plate....
Gentlemen A question to the welders and boat builders on the forum. I have a CIG brand 275amp mIg 3phase, that i use with a spool gun for my...
Colleagues While restoring my latest project, I have failed to come across any foam floatation in the hull of any significance. I must admit I...
Colleagues I have a 22' aluminium boat which I am rebuilding, the Volvo Penta motor AD31B wich is removed at present showed on the Hour meter...
Colleagues I would like to ask the more electrically minded than myself, how would you make or measure stray currents in your electrical wiring....
Colleges This subject has reared its ugly head again and I would like opinions on which is the correct method. We have an Aluminium boat,...
Friends We all know for some reason or another we can not mix copper and aluminum on boats, especially those with aluminum hulls, due to the...
Colleagues I want to add a couple of drainage bungs to my motor well, the boat was built and designed without these and after the years a huge...
Good Evening I am slowly rebuilding a 20Ft Aluminum boat with a diesel inboard. I have rebuilt the fuel tank and am going to replace all the fuel...
Hi to All I am planning on making a pair of outrigger poles for my boat, I have looked at whats on the market, and consider them to be over my...
Gentlemen I am in the process of a rebuild on 20" aluminum boat. There are a scattered holes in my cabin and hardtop were the previous owner had...
Colleges I am in the middle of a full strip down and restoration of an aluminum 20' boat, I have removed the under floor fuel tank which sat in...
Gentlemen I am trying to remove the leg of a volv0 290 sp, I have followed the manual with no problems till now. I am at the stage were I have to...
Colleges I would like to know the theory or if there being one on bod extensions to the transom of the boat, I have a plate Aluminum boat with...