Hi Kirsty Coming from a different background I have to agree that foam as you put it is the way to go, but not just any foam. What you want is...
Gentlemen What I have done is bent with a radius 5mm 5083 to 90deg and cut them length wise to form a slight taper. these will be fully seem...
G'Day Gentlemen Just a quick update from back then, after completing the repairs and reading the posts, a bit of soul searching, and a moment of...
G'Day Again Friends I just happened to come across a new push pull gun at the right price and want to use that instead of the old spool gun. The...
Gentlemen Once again thank you for the information. The drawing that TANSL has posted is basically what I have done, except for the new backing...
Gentlemen Thank you for the replies, the 6x12 strips I was figuring that they would act like a brace or a stiffing seam along the hull where the...
Colleagues I have being rebuilding a certain hull for quite a while now, not to get too much into that, but a brief description a 20' planing...
Yep, Good on you Frosty, basically confirmed what i was thinking. Just wasn't quite sure if thay had special rubbers or whatever? I will remove...
Colleagues Still rebuilding this boat of mine but edging closer day by day, I have being searching for tilt cylinder rebuild kits and have found...
Gentlmen Thanks for the replies, and yes you're 100% correct on what you have said. Except the question was asked not to fill holes but to be used...
Boston PM sent to you.
Boston Good to see your getting there with it. The way your doing it is the best way, with a heap of small batches, once you get to know the oil...
The boat is trailerd, no real need for anti foul, your second point is the one I'm worried about, if it starts too lift its going to be corrosion...
Frosty Biggest Problem is we don't have access to the bottom plates through the boat, the deck is fully welded in and I was not prepared to...
Colleagues I am coming nearly to the end of quite a lot of hull repairs I have done on a aluminium hull rebuild. They were originally corrosion...
These Aircraft wires sound fantastic, but Ill state again in Aus aircraft dismantler's are as rare as rocking horse s**t. Would anyone have then...
Without getting to technical, why is the length a round trip? In mains power or even larger DC power we design from power unit or outlet to motor...
Gentlemen When determining the length of cable to be used in the calculations is it the length from battery to starter? Or from battery to...
I found a really good little program , free download what gives you everything you need, to those that are interested....
Gentlemen Again lots of information. You're all correct in the shock of the price of cable, excuse the pun! at nearly $30.00 meter for 4/0 is...