Hello everyone, I'm wondering if anyone knows what type and thickness of foam I can substitute in place of plywood. Ie: plans call for 1/4"...
I recently bought this 14' catamaran but I have no idea as to the make of it. It's fiberglass hulls with plywood bulkheads, daggerboards and is...
Just wondering as to how hard it would be to make a mould of a pre existing hull. I have a wood sailing dinghy that I am tired of fixing and...
Hey everyone, I was checking my boat in preparation to go out for a sail tomorrow when I noticed a bit of blistering on the inside of the hull in...
I'm not sure if this is in the right section, so Mods feel free to move this thread as you see fit. Hello everyone, I have a bit of a dilemma...
Hey everyone, just a general information question this time. Does anyone have a conversion chart or does anyone just "know" the conversion when...
Hey everyone, I was wondering if anyone had any advice on what the "optimum" pop rivet pattern is when splicing a mast section back together where...
Hi all, I was doing some repairs on my powerboat back in October using Westsystem 105 Epoxy with 205 fast hardener and 403 filler. I followed the...
Would cutting a 15' fiberglass canoe in half at the widest point and glassing a 1/2" plywood transom into it make a stable, usable 7.5foot dinghy...
Hey again everyone, I have a few performance questions for the forum gurus. Which hull type is quicker "over-all" flat bottom? Rounded?...
Hey everyone, for a while now my family has owned an old 9' Davidson sailing/Rowing dinghy, currently it is in need of some pretty extensive...
Hey everyone, the mast I currently have on my 16' tri is a slightly modified Nacra 5.2 mast, with the old style main halyard system (pulled down...
Hey everyone, I have a 2hp Suzuki that runs really well, the only problem is that the on board fuel tank is only good for about an hour and a half...
Hey everyone, I'm looking for a stock, classic rig, aluminum Tornado mast and mast step in good, usable condition. If anyone has one I'll be...
Hello again everyone, I'm just curious if anyone, hopefully those who also own B33's have any advice on water stays, mine is missing them.
Just wondering, as I have a spare Tornado rig, if it'd be "too much" for my 16' KH trimaran. What it has now is the rig off a Nacra 5.2 with 18"...
Hi guys, I was wondering if any of the racer builders out there had any ideas as to what, for performance and control on a 33 foot Buccaneer...
Hey everyone, I have a 6cylinder 125hp Ford Lehman diesel engine that I'm wanting to sell. I has less than 4800 hours on it, runs beautifully and...
I'm trying to figure out a way to ad a kick up rudder to my 33 foot Buccaneer. I'm wondering if anyone has plans for a Kurt Hughes style kick up...
Is anyone familiar with this boat designer? Their designs look very interesting. http://www.antrimdesign.com/trimarans/ -Wolf