I Need A Rudder For A 1988 Cruisers 2970 Esprit Can Anyone Send Me A Link...
Hello again my boat design friends!!!!! Cleaned the carb and got it to idle but only with the needle valve almost completely shut and can't get it...
Thanks guys it was a bad tube in heat exchanger:( Now this motor is a 224/165hp mercrusiers does anyone know what type block and motor it ...my...
This motor has a closed circut cooling system (fresh water) and while trying to adjust shifting lever and cutoff switch i filled the coolant...
I'm having a problem adjusting my cut off switch..it looks like previous owner had someone put one on but this none is just a button switch not...
Had new gimbal bering put in last year by a marina and this year i'm getting a noise when i turn port and starboard could this be the universal...
Thanks everyone for ring help now I have another question about the head bolts.The service manual says to coat the head bolts with a sealer but...
I'm rebuilding my 1987 3.0 L mercrusier because of smoke out of valve cover and found a blown head gasket and two pistons with stuck rings any...
The only numbers I have are Transom #OB853830 Drive unit # OC348383 on one stern drive the other one's number is OB865683 are these alpha 1's if...
One motor that i'm going to be using has the delco est distributor can i switch the point distributor that I have on my parts motor with no...
Got parts ;got it running; but I'm getting smoke out of the vent tube on the vale cover.... motor was sitting for a long time is this normal or...
can anybody help me identify this manifold on a 1988 glastron sx-17 3.0 liter merc.. i'm trying to get parts to reconnect the exhaust system and...
Having problems with running at high speed replaced fuel pump kit and it runs at full speed for a while then bogs down and runs shitty then dies...
i'm having problems adjusting my reverse limiter switch it seems that i get it adjusted for foward an neutral and it not right for reverse an it...
hello again whats the best steps to repainting my outdrive..the barnacles last year were terrible and now all the paint has been removed.. i have...
Well i went ahead and pulled motor now with this bad omc design i have to pull inner transom bracket got it loose but y pipe is in the way an the...
:(I found a hole(leak) in one of my tilt trim lines... Marina says motor has to come out to fix line(1st problem) and line is obsilete(2nd...
one my tilt trim lines on my omc cobra outdrive has a leak in it .do i have to pull alot of parts to get to the fitting block\ on the transom i...
does anyone have a manual that they could send me the step by syep instalation of my lower unit. took off the lower unit to replace water pump...
my trim and tilt for my outdrive runs and sounded empty i filled it but still wont raise or lower my outdrive does it have and impeller that might...