I Need A Rudder For A 1988 Cruisers 2970 Esprit Can Anyone Send Me A Link...
Hello again my boat design friends!!!!! Cleaned the carb and got it to idle but only with the needle valve almost completely shut and can't get it...
Thanks guys it was a bad tube in heat exchanger:( Now this motor is a 224/165hp mercrusiers does anyone know what type block and motor it ...my...
antifreeze mix
This motor has a closed circut cooling system (fresh water) and while trying to adjust shifting lever and cutoff switch i filled the coolant...
I'm having a problem adjusting my cut off switch..it looks like previous owner had someone put one on but this none is just a button switch not...
what do you think it could be i pulled the out drive and the gimbal bearing is in great shape so are both bellows and theres no play in the...
what would happen if i left them out
and is this really nessecery for normal operation
sorry i guess i called it wrong it's the water shutter in both sides of the y pipe
Hey cdk took off outdrive bellows gimbal and exhaust all in great shape but i found a melted flapper valve stuck up against the shifter shaft in...
bearing is less than one year old
Found no holes or tears in bellows
Are You Talking About The O Rings At The Front Of Driveshaft
Had new gimbal bering put in last year by a marina and this year i'm getting a noise when i turn port and starboard could this be the universal...
Thanks everyone for ring help now I have another question about the head bolts.The service manual says to coat the head bolts with a sealer but...
there are no scores I believe there just stuck because of sitting for a long time I got this motor in another boat that was cheaper than getting a...
I'm rebuilding my 1987 3.0 L mercrusier because of smoke out of valve cover and found a blown head gasket and two pistons with stuck rings any...
But can I switch to points dist.with no problems