Great tease Agro.......where's the rest of the photos???? Only two photos? That's down right wrong!!!
Thanks guys for the information. My main problem is, back when I got my engineering degree, only one guy in the class had a calculator.....calcs....
I'd like to design a small boat using freeship. Can anyone tell me if after I complete it on FS, would I be able to print out cross sectional...
Ooooooooooooooh K!
Forgot to add above that I live at 4100', so I have a substantial power loss...more like a 3hp instead of the mfgr rating of 4.
Looking for performance experiences Hey all. I built a sweet little longtail, ala Pistonbrokes 6.5. Because I used the chain/gear setup, I am...
PB, does the "wasted spark" affect how the tach works? I ask this as I bought one of those tachs from Jim, and when I select the 03 option, spark...
Do you think it would work if I were to gear it down like you did?
PB, can I ask your opinion on using a 7x9 prop on a 4hp 4 stroker? Could it be run w/o reduction, or do you think it would be better with? The...
Thanks PnB, I should have been more specific in my request. I am building a longtail like you did, but with the free 4hp BS (perhaps you remember...
Does anyone out there have some means of calculating which prop to use if certain parameters were known about the motor used and the boat used,...
Thanks L2C, I thought that might be what it was. I seem to remember reading about some type of expansion chamber for when the lube gets heated and...
I have noticed on some of the larger long tails something that appears to possibly be some sort of reservoir up near where the drive shaft...
I have been reading the threads, and there seem to be proponents of each method of power transfer from the engine to the prop. I thought the...
PB, I did study the diag. and pretty much follow everything you have there. Since the drive tube, was not included in the diag., it appears you...
One more question How thick is the wall of the 25mm galv. pipe?
Thrust bearing installation PB, did you have to machine a taper in drive tube to accept that tapered thrust bearing? I've only seen them used on...
A duropower question for john John, it appeared that you were working diligently on your duropower conversions, but then switched over the the...