Quite so. If anybody can point me in the direction of a wiring diagram for the alarm circuit, I'd be grateful. I think, whatever the circuit in...
I quite agree - having blown up an engine partly due to a faulty temperature sensor, checking fluids etc before heading off into the wild blue...
Thanks for that. No, I haven't tried it with oil, but it's not giving me the behaviour I'd expect without oil, so I think the sensor electronics...
Hello, I have an OMC type remote oil tank that has some sort of level sensor inside it; [ATTACH] It looks like a simple on/off level sensor,...
Thanks for your continued help with this :) I can certainly see the sense in pre-mixing to 100:1 to avoid damage - how would a retro-fitted pump...
Hello all, thanks for your replies! I've got a Johnson V4 115hp - a J115TLCIM. Does that mean the VRO tank actually has a sensor in it,...
Having done a bit more research, apparently OMC/Johnson/Evinrude started fitting a system called VRO (Variable Ratio Oiling) to their engines...
Hello, according to the good old internet, FICHT started making motors with OMC after 1997, so my engine predates that by about ten years....
Hello, the replacement outboard I'm currently wiring into my boat is an eighties two-stroke Johnson motor and has come with an external...
Hi CDK, thanks for that - it's certainly a thought. To be honest, I should have thought about this before I made up a new instrument...
Hello, I'm looking for some advice on wiring up an ammeter on my boat. [IMG] I have two batteries in parallel that are connected to...
Hello both, thanks very much for your advice. Based on this calculator, I reckon AWG 3 would result in about a 0.5V drop at the starter...
Hello, I'm currently plumbing in a Johnson v4 115hp 2-stroke outboard and need to replace the starter cables. At present, they're about...
Hello, I thought an update was due on this job - sorry if this counts as resurrecting an old thread... I got hold of a 7/8 die-nut and...
Oops - misread that! Thanks...
Hello all, thanks again for your help with this - quite a few options to consider now, thanks :) I can get a 7/16 UNF nut here in the...
Hello both, thanks for your advice - I see the problem with using a die - I was hoping that cleaning as much of thread as I could we be good...
Hello all, thanks very much for all your replies - bowing to the common theme of what a nightmare job this will almost certainly be, I've...
Hi, the puller's a good idea - I think I'll go down that route, thanks! :)
Hello chaps, thanks for your thoughts. At present, I'm thinking of hanging the engine on a hoist and trying to drift out the tube with a...