I recently aquired a wooden boat. It has been built to a blueprint that I'm trying to get a hold of. It's 19' long and a beam of about 6 1/2 feet....
What Color Is The Wire?
I need some recommendations on the best way to add two verticle hard top supports to my lobster style boat. These can also double as hand grab...
Hello, I'm thinking about adding a cabin hull liner to my 22' boat. Can anyone suggest hints, adhesive, and measuring technique to do this....
How fast are you going? Are you approaching the wake head on? This boat is similar to the Carolina Skiff. They are wet boats!!
Hello, Well, yesterday I pulled my boat for the season. I was using the public docks & ramp in RI. One of the docks rub rails had a piece of...
Would you recommend if using plywood, to roll a couple layers of epoxy like West Systems on the plywood sides then paint them, or just bare plywood?
I have an older Lobster style boat. I want to fabricate Hard sides with a couple of sliding windows. This will protect from side spray and wind...
Woodboat, Good info. I think I'm looking overall for the best long term solution to my ventilating problem. What's funny is that the boat...
Nevd, Thanks again for the input. I run a Yamaha prop. I'm trying an aluminum prop until I get into the ballpark. I started with a 17 pitch and...
O.K. I got the motor to the point where the boat planes out nicely, I have no spray, but I'm getting some ventilation. I posted a previous thread...
Well, I finally got the bracket mounted, and the motor at the correct height. The question I have is with a 17 pitch prop I was ventilating when...
Thank you to everyone that helped with input on the positioning of my motor on my bracket. However I had an incident on Saturday May 8th. I...
Thank you for the help. I'll let you know. John P.
Would this cause spray?
The trim angle is between 2-3 on the Yamaha Tach. This is a brand new motor and prop. The problem is more defined at lower RPM's. I do have a...
I'm not sure but I don't believe it is. The spray is more defined at lower RPM's when the boat planes out ther is less spray but the rooster tail...
I have an outboard mounted on an Armstorng Bracket (new boat). On my first run I noticed that I'm getting quite a bit of verticle spray on either...