As far as the two pumps go it will only be for testing as we already owned them, at 10 gpm they are a little undersized for task. Each pump will...
On our we are planning to use (2) 16hp honda engine driven power pumps. Each unit is rated at 10 gpm at 2000psi. This will only be for the test...
I agree with the cooling aspect of the set up, ours will be used in fresh water so we are building the lower unit in an open tube on the end of...
Is there any reason you can not allow the unit to be open to the water? If the hydraulic oil can't get out the water can't get in. I would use...
Tim, We are using a pair of hydraulic power packs each is a 16HP Briggs & Stratton vtwin attached directly to a 10 GPM, 2000 PSI pump. We also...
Hi Tim, I will get all the information I have on the units to you over the weekend. I did receive your messages but was unable to respond....
An update on our progress: We picked up a pair of hydraulic power packs each is a 16HP Briggs & Stratton vtwin attached directly to a 10 GPM,...
Thank you, will keep the post upto date as progress is made
Thank you for all your replies. I did pick up schedule 80 pipe, 3 inch for the down shaft and 5 inch for the lower unit. I was going to put the...
Fred, Thank you for the reply, as far as enduarance that should not be an issue. Almost all the time would be at or near the dock itself. Once...
Rick and Gonzo, Thank you for your replies. Do you have a recommended RPM at the propeller? If it helps I attached a few photos of the...
We have a 30’ x 12’ x 3.5’ steel barge all .25” plate which weighs approximately 17,000 lbs. It is used for dredging around our dock area; when...