Hi Andy. I have suspended the work because I am busy with some other duties. Up to now I have done the following: Taken the output of hullorm,...
I want to disregard some aspects, in fact thickness is small with respect the other hull dimensions. I plan to simulate ply just like a thin sheet...
I know. Actually I have inserted one E value for fiber direction and another for cross fiber direction. Do you think that I must use different...
I have searched it, not found, I want to write it. I have written my first program in 1972... I can do it... I have searched the forums, I see...
I have evaluated exactly the same solution, discarded it because the tube would take too much internal height (I am 6'2")... Here you can see my...
I know it, but i see two weak points: 1) don't fit in my hulls... :D :D 2) it relies mainly on dolphin striker to support mast load You are...
The problem is that I need one hard surface for hinges. I have some ideas about how I must do it, but I am interested to alternatives... I think...
Ok I am building one 8 m (26') trailerable catamaran. In my project beams are 3, composite, demountable, bolted to hulls. But now and then I...
Tanks all, I have made my home work and I have trasformed to metrics the Eric's excel sheet... Paolo
I have printed your booklet and stored it next to the Larsson book... May be that you can direct me to a metric version of The S# formula? Or I...
Not so close... It appear that whas usual courtesy for passengers to pass close to islands to see the islanders say "hello" to the big ship......
difficult to say... not enough detail... but the place is extremely close to the rock coast... it can be a rock underwater... Paolo
In this image where the ship is now. [IMG] in this image a small part of "the hole" note the unbelievable size of the stone inside... and...
I have (ordered at least... must arrive) the english translation of gutelle, but it is a reduced version, the french one is a 3 tomes book, the...
I am looking for a copy of french version of Gutelle, 3 volumes... It looks impossible to find... ARCHITECTURE DU VOILIER, Pierre Gutelle...
Rob my mast will be 10 meter long, (33')... I have seen Ronstan catalogue, maybe the PNP150 is what I am looking for... do you plan to build...
Eric, I have a sailtrack sample on the desk, the track is 35 mm wide (1 3/8), much larger than Antal... don't know if a smaller model exist, but...
Hi Eric! Tank you for your replay. Disregarding Harken (too big, too expensive) the smallest Antal track, the one suitable for my (future...)...
Hi all. Back on the subject of wing mast... I would like to have suggestion on the best sail slide to be used on a wing mast... The problems...
I was talking with a friend at the club bar, my friend owns one monohull, a first 211, him uses the boat mainly for local and club regatta,...
