The fuel cap and the location where it will stay. The hull you see is the inner hull. The wider white frames are reinforcement, the cyan are the...
Fuel cap. [ATTACH] [ATTACH]
Frames fuel tank and ballast deposit. [ATTACH]
I've been busy, the drawing now goes a little slower. Study the position of the frames and fuel tank supports, as well as the ballast.[ATTACH]
Reduce the model I’ve made and start making the frames. The frame party will start. [ATTACH]
Propeller shaft support brackets completed. [ATTACH]
Working in the propeller shaft support brackets. [ATTACH]
Propeller LH and RH done. [ATTACH] [ATTACH] [ATTACH]
I'm trying to draw a surface propeller, I do not want anything too technical. What I'm looking for is the length of the hub and the outside...
Trim tab, the buttons on the steering wheel are for this. [ATTACH]
Small details. [ATTACH]
Rudder and rudder hardware. [ATTACH] [ATTACH]
Today was the day to put all the vents in place, when I made the cut of the deck the stain in the hatchs no longer exists. [ATTACH]
The round hatch is made as well as the sticker is in place. [ATTACH]
I have all the cleats done. Next will the navigation light, and the round hatch that exist between the fuel hatch and the forward central cleat....
"U" bolt and deck rail, I am working in the cleat. Initially I made the rail deck holders thinner, after I looked at a few moments it has needed...
Engine hatch. [ATTACH] [ATTACH]
Steering wheel was completed and with color, I needed to make a few changes, It is time to draw the seat. A render. [ATTACH]
Steering wheel, the hardest part is done.[ATTACH] [ATTACH]
Fuel hatch. [ATTACH]