yep. They also use 3 sealed bearing one on the upper end and, two on the lower end. Nothing for center support. The only welding on them is for...
2inch top, and 8 inch bottom pullies. As far as the prop. I purchased it form the outboard manufacturer. I'm not really a fan. Made of mild...
Muddin Redneck, the reduction on mine is a 4:1 the company that manufactures them uses a 3:1 if i remember right. I will check when we get them...
hthttp://www.boatdesign.net/forums/images/attach/jpg.giftp://whttp://www.boatdesign.net/forums/images/attach/jpg.gifww.boatdesign.net/forums/imhttp...
Wow. In my first post what I ment was. 90 degrees as viewed from above, And the splasher would be positioned toward the front of the kart. I...
Thank you. When i did the thia. I was in debate between the longer shaft(more rotating mass vs u joint and loss of torque. Thank you for your...
And what are your beliefs on energy loss tho the u-joint? If you dont mind me asking. Thank you for your replie.
6.5 angle & oiling First time poster, long time lurker. After removing the governor, I came to the conclusion that the 15 degree rule of thumb...