Thanks
Very usefull infos TANSL. Thanks for helping
I have about 5300 fiber units : 1x csm 23 matt 1x csm 225 matt 2x csm 450 matt 1x triaxial 900 4x csm 450 matt 1x triaxial 900 2x csm 450...
Hi to all, Any idea where can i find prepreg carbon in Europe ? Regards George
Thanks TANSL for the infos. I agree with your last post but i'm afraid the 5mm thickness of the laminate.....the stress cracks, the damage in a...
Last month i build a 10m rib two times, one with hand lay up and one with vacuum infusion. In the first case the thickness of the laminate is...
Thanks Tansl for the reply, The only carbon fibres choice will reduce the thickness about 2mm. Will be good or have problems in stiffness ?...
Hi to all, Nowadays i start a new project about a 2,40m rib tender. I have made the mold (hull & deck) and my first thought is to build it...
Thanks for the advice
Thanks Gonzo
Hi to all, Last week i buy a 5m racing boat mold (hull & deck) and of course i have some thoughts to do serial production with this. I'll...
Thanks or the reply
Hi to all, I have a shipyard and nowadays i finish a 10m fast rib mold. I'm ready to start a 10m fast cabin rib for production. My customer...
I try a lot of laminate between 50% - 80% vacuum but i have the same problem when curing. If you send me your mail i can send you some...
Thanks for your help. I'll try a laminate in the middle of the week and i mail you. Regards
Thanks Maniek for the quick reply. I use classical fiberglass 450 but i have the same problem if i put triaxial. Thanks
Hi to all, Last month i start to infuse panels for my boats. I use polyester resin (not vinylester or epoxy) with mekp catalyst. During...
Hello to all, My name is George and am boatbuilder, the main sector is rib & inflatable boats. Nowadays i finish my last project which is a...
Dear steve, Thank you very much about your interesting, i apriciate it. I'll try to contact with these three shpiyards and i'll tell you....