Hi guys, any expert on MIG aluminum welding among you? We have to MIG weld aluminum grade (5083H116) 4 and 6 mm hull plates by butt joint. Now...
Hi there, Could anybody suggest source, source to purchase existing , design plans, vaccum infusion, ( tuna tower, tuna door etc) for classic...
Can anybody explain the purpose of those short bow "spray rails" above and parallel to the WL which we can see more and more on fine entrance...
By chance does anybody know designer name of this glass bottom hydrofoil boat as attached hereto? I know the company which is building her from...
Hi there am looking for houseboat cat hull bilding plans of approx. 18/20 mt. length This attached one could be suitable Do you know who is the...
Hi there! Does anyboy know where bulding plans for such nice old fisherman of approx 12 mt. length could be available? Thanks for any...
Hello there, My intention is to purchase a stock building plans for a motor boat approx.50' from Bruce Roberts. Is anyone there who has some...
Hi, I was wondering whether anybody has got any data/drawings about this boat from the 30'-40s'? I would appreciate any help. Thanks Adriano:)
Hi there, Am sure there are skilled guys in this forum who could give me some good advices. Am aiming to reshape an old Italian rowing canoe...
Hi there, Does anybody have a tip how to simply take a wood veneer coldmoded conoe out of a building jig, without having lot of dismantelling...
Hi there, To keep costs low for approx. 5 mt.long X 0.8 mt. wide canoe if I use in infusion molding (female mold) following layers: 1st...
Hi there, Does anyone knows where building plans for the attatched canoe or similar could be available? Cold molding or strip planking is the...
Hi I would appreciate if anyone could give some feed-back on drawbacks when using marine plywood (90° to planking) both for permanent frames...
Hi, Is anyone awere of half model CNC design source. Mainly looking for those old classic sail boat designs. Thanks for any suggestions Adriano;)
is there any patent valid to be awere of concerning wood/epoxy cold molding construction? Appreciate any comments Thanks Adriano;)
Hi there, could anybody confirm whether for a motor launch hull (outborder) of 19 ft over all, approx 350 kg displacement following...
Hi there, I found on the web this cat rigged boat. Never seen before such a hull for a cat.Can anybody confirm that the entrance has a kind of...
Hi there, am about to model bulwarks and face the problem of distored grey lines like frames, buttock etc. Apparently the rule is to use 4...
Hi there, Amount of Lead is a rather matter of experiences in boat design, which I do not have much. Nevertheless I would like to design and...
does anybody have experience in using bamboo strips for strip planking/epoxy construction? Apart from being eco-friendly and low cost,...