The part will be similar to a kayak so the mold for sure needs to be split somehow which is why Im asking. The plug will be built up with ribs and...
thanks for the reply. I had indeed figured if I was to go with a butt joint and inner layers of tape the flange would be basically useless in...
Im going to be building a plug to make a composite shell which closely resembles a kayak, altho with a smaller cross section. Im planning on MDF...
Its amazing on a board that is all about designand exchange of idea's that so many of the replies to this post have been so negative! Thanks...
Perhaps I can also provide a best estimate of total surface area. Im estimating aprox 66 sq' of area. (there will be holes cut out etc) Would...
I have a general inquiry for those expereinced with making strong light parts in glass and/or other composites. Im not concerned with what...
If this design change works it will likely be seen as a radical departure from current thinking and as such I am definitely not about to go and...
Hi all, new to the forums but only as a member, been surfing for some time now. Im undertaking to design a new hull for a certain form of...