The boat Is 20 Foot GRP and I have removed all the interior bar a few bulkheads. I debated using the tick stick method and making cardboard...
Where my confusion tends to lie at the moment and is going to influence my choice is paint manufacturers and Epoxy manufacturers seem to overlap...
I have debated it but to be honest Id just like some line drawn plans with accurate measurments of the boat Im restoring. At this moment in time...
After reading through their website I think Ill give them a call tommorrow. It does look like a well supported excellent product. I suspect this...
Are there any good write ups / books or anything anywhere on reverse lofting a boat. I would like to draw some plans of my boat in autocad but...
That sounds excellent as a generalization what are they like cost wise to the other well known suppliers. My original list was created from...
Your the second person to use SP (gurit). I have never heard of it (not that I should of being a beginner). Why is it your choice and what is so...
Im curious to see which epoxy products people use and why. I would like to choose a particular one and stick to it. My choices are West system...
I also found this article which i think is also relevent http://www.yachtsurveys.co.uk/faq_osmosis.htm basically on the premise that its not...
I contacted the guy who made the original post and this is what he kindly responded. 'Ahoy! yes, this address is still good. Essentially you...
As long as the moisture can escape and isnt sealed in I dont see why it wouldnt work. The vacuum pumps are normally used to remove all moisture...
I have spoke to a refrigeration and air conditioning friend of mine and he thinks it would work as well. Effects Of Pressure and Temperature...
I was reading this on another forom looking for something un-related "Hi Buzz! Among the MANY things I have done with my E-37 over the 15...
Hi Im going to replace the woodern floors in a GRP boat. At the same time i would like to repaint / seal the bilges. Firstly Im going to remove...
Ive taken some photos of the Floors that need replacing just for reference. http://www.technical-solutions.co.uk/HurleyFelicity/Default.htm
haha To be honest I was going to use Autocad 2010 as I dont need it to test the designs just draw them. Just curious as what other people used. I...
Hi Par although a bit off topic what software do you use for drawing your Boat plans.
Finally the bilge holes [IMG] As my not very well drawn picture shows currently there are bilge water holes in the rear floors ( Not all...
Excellent Where the nuts are screwed onto the bolts would you just use large washers or a small plate maybe.
Yes that does make sense. So by laminate you mean a 'block of wood' made made from strips of wood epoxied togeather along the grain and when...